設為首頁 | 收藏本站
2D70耐熱鋁合金顯微組織均勻化熱處理2017-02-09 15:51來源：中鏨集團SinoAV作者：通項公司TXCO
2D70耐熱鋁合金顯微組織均勻化熱處理Homogenization treatment and microstructure of semicontinous casting ingot of 2D70 heat-resistance aluminum alloy 利用光學顯微鏡、掃描電子顯微鏡、能譜分析、差示掃描量熱、X射線物相分析研究2D70耐熱鋁合金半連續鑄錠的結晶相及合理的均勻化熱處理制度。結果表明：合金半連續鑄錠中枝晶偏析嚴重，存在大量非平衡共晶相，其成分為α(Al)+θ(Al2Cu)+S(Al2CuMg)，其初始熔化溫度為505.4 ℃；在530 ℃溫度以下進行均勻化時，合金中的難溶相Al7Cu2Fe、Al7Cu4Ni、Al9FeNi含量基本沒有變化；合金合理的均勻化熱處理制度為(490 ℃, 16 h)+(520 ℃, 16 h)。 The constituents of the semicontinuous casting ingot of 2D70 heat-resistance aluminum alloy and homogenization treatment were studied by optical microscopy (OM), scanning electron microscopy with energy dispersive X-ray spectroscopy (SEM-EDX),differential scanning calorimetry(DSC) and X-ray diffraction analysis (XRD). The results indicate that the semicontinuous casting ingot of 2D70 aluminum alloy presents a dendritic microstructure with severe segregation. The phases of the nonequilibrium eutectic are α(Al)+ θ(Al2Cu) +S(Al2CuMg) whose overheating temperature is 505.4 ℃. The volume fraction of hard dissolve phases such as Al7Cu2Fe, Al7Cu4Ni and Al9FeNi changes a little below 530 ℃. The reasonable homogenization treatment process of the alloy is (490 ℃, 16 h) +(520 ℃, 16 h). 下一篇： 2E12鋁合金的高溫塑性變形流變應力行為
|
